Step #01: Move The Passenger Seat. Step #02: Remove The Carpeted Panel. Step #03: Remove The Metal Panel. Step #04: Start With The Negative Panel. Tips For Maintaining The Battery In Your Jeep Grand Cherokee. Check Battery Charge Level And Condition. Clean The Battery And Terminals. Properly Store The Battery. Conclusion. 2017 Jeep Grand Cherokee battery location and replacement (Main and Auxiliary battery) The 2017 Jeep Grand Cherokee auxiliary battery location is under the passenger seat, alongside the primary battery. Unlike many other models, the batteries in the 2017 Grand Cherokee are located beneath the passenger seat. You’ll need to remove parts of the seat to access both batteries. You will need a Phillips head screwdriver. 2006 Jeep Grand Cherokee. 2005 Jeep Grand Cherokee. 2012 Land Rover Range Rover Evoque. Find a Location; All Battery Center; Dealers; Distributors; Nkpdor. The Cherokee KL 2014 -2019 has only one battery, located in the engine compartment. The Grand Cherokee has two, if equipped with ESS. The Cherokee KL 3.2L V6 models 2015-2019 have all been equipped with ESS (Engine Start/Stop) and require an AGM (Absorbent Glass Mat) battery. Reviewed by Shannon Martin, Licensed Insurance Agent. Unlike many cars with simple, under the hood access, your 2019 Jeep Grand Cherokee is located underneath the passenger seat. To replace the battery, you’ll need to move the power-adjustable seat as far forward as it can go. After it’s been moved, you’ll see a panel in the floor where To open it remotely, press and hold the button on the key fob that says “hatch” until you hear a click. Locate the rear hatch release button inside the jeep grand cherokee. This is usually located near the driver or passenger seat. Press and hold the rear hatch release button until the rear hatch begins to open. If your 2012 Jeep Grand Cherokee uses a battery to power the sensor, be sure that it is not dead. It is a good idea to replace the battery every five years. Sometimes this requires replacing the entire sensor unit since the battery is built-in. Step 3: Remove One Battery Cable. Once you lift the panel from the floor, the next step is to remove one of the cables. Start with the negative battery cable; you will need a wrench to loosen the fastener on it. You may already have a handy wrench for this purpose, so pull it out and use it at this point.

jeep grand cherokee 2012 battery location